This section describes the various toolbar commands available
in the Electrical Harness workbenches.
The toolbars are located on the right in the default set-up except for the
Catalog Browser, the Measure and the Update commands which are located in the
horizontal bottom toolbar.
Creation Toolbar
Bundle Segments Sub-toolbar
Management Toolbar
Delete Toolbar
Related Objects Toolbar
Catalogue Toolbar
Measure Toolbar
Geometrical Bundle See Creating a Geometrical Bundle |
|
See Bundle segments sub-toolbar below | |
|
Local Slack See Managing Local Slack |
|
Protective Covering See Adding Protective Coverings |
Bundle Segment See Working with Single Bundle Segments in a Bundle Segment Document |
|
Multi-branchable Document See Creating a New Multi-Branchable Document and First Branch |
|
Link See Linking Bundle Segments |
Unlink See Unlinking Bundle Segments |
|
|
Add Support See Adding a Support |
Remove Support See Removing a Support |
|
Split See Splitting Bundle Segments |
|
Add Branch Point See Adding Branch Points |
|
Remove Branch Point See Removing Branch Points |
|
Transfer Branches See Transferring Branches |
|
Duplicate Harness See Duplicating Harnesses |
|
Adjust See Adjusting Relationships between Harness Covering Components |
|
Arrange Bundle Segments See Arranging Bundle Segments in Supports |
|
Copy Bundle Segment Position See Copying the Bundle Segment Arrangement |
|
Update Bundle from Support See Updating the Bundle Segment-to-Support Link |
Delete Special See Deleting Unused Branch Points |
Related Objects See Viewing Related Objects |
Catalog Browser See Using the Catalog Browser |
Measure Geometrical Bundle Inertia See Measuring Geometrical Bundle Inertia |
Select Toolbar
General Toolbar
Geometrical Element Toolbar
Delete Toolbar
Internal Protection Toolbar
Exit See Exiting the Installation Workbench (Part workbench) |
Bundle Segment Definition See Working with Single Bundle Segments in a Bundle Segment Document |
|
Branch Definition See Creating a New Multi-Branchable Document and First Branch |
|
Add Branch Point See Adding Branch Points |
|
Remove Branch Point See Removing Branch Points |
Point See Creating Construction Constraints, Creating Points |
|
Line See Creating Lines |
|
Plane See Creating Planes |
Delete Special See Deleting Unused Branch Points |
Light Protective Covering See Adding Light Protective Coverings |