What's New?

New Functionalities

Connect Checker: This section describes about the various CCK types between two curves and/or surfaces.
Check connections between surfaces: Select two surfaces, specify the type of analysis (distance, tangency, curvature) and set the analysis parameters.
Check connections between curves: Select two curves, specify the type of analysis (distance, tangency, curvature) and set the analysis parameters.
Checking connections between curves and surfaces: Select one curve and one surface, specify the type of analysis (distance, tangency, curvature) and set the analysis parameters.
Tolerances: This sections describes about Tolerance values.

The new control point command should provide more standard behaviors such as selection, undo/redo, integration in CATIA.
Using Control Points: Selection and advanced customization of control points.
Creating Delta Analysis/Delta Deflection: Usage of options like Delta Analysis and Translator Delta Display.
Extend with negative value: Negative extension of curve.
Isophotes Analysis: The new options that have been added are: Multi band type, Show/hide the manipulator, Light Sources On/Off, and Highlight On/Off effect.
Untrim enhancements: Selection, Create Curves and Create Extract options have been added to the Untrim dialog box.
Break Enhancements: Breaking curves and surfaces.
Continuity Constraint Evolution: Creating FreeStyle continuity constraint.
Stylling a Fillet: Create an ACA fillet surface between two given surfaces using Styling Fillet.
Draft Analysis Improvement: Performing draft analysis shader.