What's New?
New Functionalities
- Multi-Axis Spiral Milling
-
Enables you to machine pockets (with computation of bitangency between the
pocket bottom and the pocket side) or to engrave complex surfaces.
Enhanced Functionalities
- Definition of the
tool axis,
machining direction or line or axis direction, ...
- An icon has been added in the dialog box to set those directions directly to the normal to
the screen, in Manual mode.
- Enable multi-editing of machining operations of the same type
- It is now possible to perform multi-edition of certain parameters on two
or more machining operations of the same type. This capablity is available on
Multi-Axis Flank Contouring,
Multi-Axis
Curve Machining,
Isoparametric
Machining, and Profile Contouring.
- Multi-Axis Curve Machining
- The definition of interpolation axes has been made easier and proposes a check of interferences.
- A new tool axis guidance strategy is available:
Thru a guide.
- In Contact and in Between curve and part modes, you can now select a
plane
as the part to machine.
-
Multi-Axis Sweeping
- A new tool is available: barrel
tool.
A new tool axis guidance strategy is available:
Thru a guide.
You can now select a limiting contour with a
possible
offset.
-
Multi-Axis
Contour Driven
- A new tool axis guidance strategy is available:
Thru a guide.
You can now select a limiting contour with a
possible offset.
- Multi-Axis Tube Machining
- Guiding strategy: Along guide has been added.
Driving tool points: two computation methods are now available: Tool tip
or Contact on part.
Zone: three
machining zones are now available: Tube, Cavity, Tube and cavity.
- Isoparametric Machining
- The definition of interpolation axes has been made easier and proposes a check of interferences.
- A new tool axis guidance strategy is available:
Thru a guide.