Placing and Modifying a Part
Ways of placing and modifying a tubing part
are discussed in this section.
There is a Tools -> Options
setting that is not supported and should not be used. Under General
-> Parameters and Measures, and the Knowledge tab, do NOT
check the option
Interactive Synchronization at Load. Instead check the option
Automatic Synchronization at Load.
Placing Parts
How Values are Assigned to Parts
Switching Graphic Representations
Adding Insulation to a Part
Rotate a Tubing Part
Flipping a Part
Inserting a Part
Placing Transitional Objects On a Run
Detecting Clash in Parts Placement
Placing a Part in a Sub-document
Requirements for Building Parts
Query or Convert Auto Parts
Adding and Managing Loose Parts