Create plates: set parameters in the dialog box then select a support plane or surface, and if necessary define a contour. | |
Create end plates: set parameters in the dialog box then select the end of the shape at which you want to place the end plate. | |
Create shapes: set parameters in the dialog box then select an existing support or define where the shape starts and ends. | |
Create small assemblies: select a catalog assembly then existing shapes or plates to position it. |
NOTE
In R15 and later releases, do not use the Type drop down list in
the Shape dialog box to choose a catalog.
To select a different catalog:
You can modify your project resources management (PRM) file.
You can create a new PRM (recommended if you don’t want to modify your PRM
because of several resources for your project), and point to the new one
before instantiating SR1 shapes.