This section explains and illustrates how to create and use
various kinds of stamps.
The table below lists the information you will find.
Create a point stamp: select a point on a face, and set the stamping parameters. | |
Create an extruded hole: select a point on a face, and set the stamping parameters. | |
Create a curve stamp: select a sketch, and set the stamping parameters. | |
Create a surface stamp: select a sketch, and set the stamping parameters. | |
Create a bridge: select a point on a face, set the stamping parameters, and select an edge to give the bridge orientation. | |
Create a louver: select a sketch, and set the stamping parameters. | |
Create a stiffening rib: select the external surface of a bend, and set the stamping parameters. |