 |
This task shows how to create a Body in White
spot point. |
|
There are several ways to create a spot point:
- a joint and a
joint body are already created: click the
desired icon and select the joint body in the selection tree.
- a joint and a
joint body are already created: select
the joint body in the selection tree and click the desired icon (here
is the example used for our scenario).
- no joint body is created. Select the components or the
publications, and click the desired icon: a joint and a joint body are
created.
|
 |
Open the
SpotPoint1.CATProduct
document. |
| |
 |
Make sure the spot point Fastener Type is set
up in the standard file. |
|
 |
-
Select the joint body in the specification tree.
-
Click BiW SpotPoint
from
the
Unspec Process
toolbar.
| The BiW SpotPoint Fastener Definition dialog box opens. |
 |
-
Specify whether you wish to use the existing standard
or not.
| If a standard has been
imported, a spot point is created using this standard. If not, you
are able to define your own values for each attribute. |
-
Define the spot point's following parameters:
-
Click OK to create the spot point.
| The spotpoint (identified as Joint Element.xxx) is added to the
specification tree, under the Assembly Joint Body node. |
|
|
 |