Before you start your first working session, you can customize the way you work to suit your habits. This type of customization is stored in permanent setting files: these settings will not be lost if you end your session.

  1. Select the Tools > Options command. The Options dialog box displays.

  2. Choose the Mechanical Design category in the  left-hand box, then Mold Tooling Design.

You will find the Mold Tooling Design options in the following tabs:

  • Catalog, that defines the storage location of catalogs,
  • Add/Remove that defines the target bodies for drill holes, tap holes, pads and pockets,
  • Component, that defines the components options.
  1. Set options in these tabs according to your needs.

  2. Click OK when done.