Interoperability Between the FreeStyle Shaper and Optimizer

  The following scenario explains about how to work in an industrial environment with the FreeStyle Shaper and Optimizer specific commands. This scenario is performed in P2 mode, because some of the capabilities used throughout the scenario are available with the P2 configuration only (all FreeStyle Optimizer capabilities for example)
 

Creating Four-Points Patches
Deforming the Surface Limits
Fitting the Surface to a Cloud of Points
Analyzing the Surface
Smoothing the Surface

This scenario is accomplished in ten minutes. It consists in creating the surface corresponding to the roof of a car. The resulting roof surface will look like this: