This document applies to all levels of AIX.
New Pinouts: 8-Wire
RJ-45 DB-9
DSR 1<---------------6 DTR
/---RTS 2
| FG 3
| TxD 4--------------->3 RxD
| RxD 5<---------------2 TxD
| SG 6----------------5 SG
\-->CTS 7
DTR 8--------------->4 DSR
These pinouts should work with both XON/XOFF and DTR flow control.
When using DTR flow control, use the 'alternate rj45 pinout' setting
for the printer device. (Altpin does logical switch DSR->DCD)
New Pinouts: 10-Wire
RJ-45 DB-9
/---RTS 2
| FG 3
| TxD 4---------------->3 RxD
| RxD 5<----------------2 TxD
| SG 6-----------------5 SG
\-->CTS 7
DTR 8---------------->4 DSR
DCD 10<---------------6 DTR
These pinouts should work with both XON/XOFF and DTR flow control.
There is no need for the 'alternate rj45 pinout' setting here. DCD
(printer) is already going to DCD (RISC).
New Pinouts: 8-Wire
RJ-45 DB-9
/----2 RTS
| 3 RD----------->TD 2
| 4 DCD<----------DTR 6
| 5 SG------------SG 5
| 6 TD<-----------RD 3
| 7 DTR---------->DSR 4
\--->8 CTS
These pinouts should work with both XON/XOFF and DTR flow control.
There is no setting for the 'alternate RJ45 pinout' setting because
there is no need for it. DTR (printer) is already going to DCD (RISC).