Supplies configuration information for the Network Terminal Accelerator adapter card.
The /etc/rc.ntx file invokes the hty_load command to load the /etc/hty_config file. This file can also specify a route to a gateway, using the ntx_route command. Also, the rc.ntx file enables SNMP.
The /etc/rc.ntx file can be used to perform different configuration tasks. For example, to supply a route to an additional gateway, add the following line immediately after the comment about additional routes, and supply an IP address for the Destination and Gateway parameters:
/usr/bin/ntx_route -drhp$i net Destination
Gateway
Following is the file as it is shipped with the software package. You can add additional commands to the file, as indicated above.
echo "Executing hty_load"
/usr/bin/hty_load -f /etc/hty_config
echo "Finished executing hty_load"
#
# Maximum number of Network Terminal Accelerator adapters
# supported on each workstation.
#
MAX_RHP_DEVICES=7
i=0
while [ $i -le $MAX_RHP_DEVICES ]
do
if [ -f /etc/rhp$i.ntx_comun.conf ]; then
echo "Configuring SNMP communities on NTX
Adapter rhp$i"
/usr/bin/ntx_comun -d /dev/rhp$i -f
/etc/rhp$i.ntx_comun.conf
fi
if [ -f /etc/rhp$i.ntx_traps.conf ]; then
echo "Configuring SNMP traps on NTX Adapter rhp$i"
/usr/bin/ntx_traps -d /dev/rhp$i -f
/etc/rhp$i.ntx_traps.conf
fi
if [ -f /etc/rhp$i.ntx_nms.conf ]; then
echo "Configuring SNMP nms on NTX Adapter rhp$i"
/usr/bin/ntx_nms -d /dev/rhp$i -f
/etc/rhp$i.ntx_nms.conf
fi
if [ -f /etc/rhp$i.ntx_descr.conf ]; then
echo "Configuring SNMP site-specific variables on
NTX Adapter rhp$i"
/usr/bin/ntx_descr -d /dev/rhp$i -f
/etc/rhp$i.ntx_descr.conf
fi
if [ -c /dev/rhp$i ]; then
STATE=`lsattr -E -l rhp$i -a snmp -F value`
echo "Turning $STATE SNMP on NTX Adapter rhp$i"
/usr/bin/ntx_snmp -d /dev/rhp$i $STATE
fi
# Additional routes for each NTX Adapter can be added here
# example: /usr/bin/ntx_route -d /dev/rhp$i X.X.X X.X.X.X
i=`expr $i + 1` # increment count
done
The hty_load command.