DL_XID_CON Primitive

AIX Version 4.3 Communications Technical Reference, Volume 1

DL_XID_CON Primitive

Purpose

Conveys an XID data link service data unit (DLSDU) from the data link service (DLS) provider to the DLS user in response to a DL_XID_REQ primitive.

Structure

The primitive consists of one M_PROTO message block, which contains the following structure, followed by zero or more M_DATA blocks containing zero or more bytes of data:

typedef struct 
{
   ulong dl_primitive;
   ulong dl_flag;
   ulong dl_dest_addr_length;
   ulong dl_dest_addr_offset;
   ulong dl_src_addr_length;
   ulong dl_src_addr_offset;
} dl_xid_con_t;

Description

The DL_XID_CON conveys an XID DLSDU from the DLS provider to the DLS user in response to a DL_XID_REQ primitive.

Note: This primitive applies to XID and test operations.

Parameters

dl_primitive

Specifies the DL_XID_CON primitive.

dl_flag

Indicates flag values for the request as follows:

DL_POLL_FINAL

Indicates whether the poll/final bit is set.

dl_dest_addr_length

Specifies the length of the data link service access point (DLSAP) address of the destination DLS user. If the destination user is implemented using the Data Link Provider Interface (DLPI), this address is the full DLSAP address returned on the DL_BIND_ACK primitive.

dl_dest_addr_offset

Indicates where the destination DLSAP address begins. The value of this parameter is the offset from the beginning of the M_PROTO message block.

dl_src_addr_length

Specifies the length of the DLSAP address of the source DLS user.

dl_src_addr_offset

Indicates where the source DLSAP address begins. The value of this parameter is the offset from the beginning of the M_PROTO message block.

States

Valid	The primitive is valid in the DL_IDLE or DL_DATAXFER state.
New	The resulting state is unchanged.

Implementation Specifics

This primitive is part of Base Operating System (BOS) Runtime.

Related Information

The DL_BIND_ACK primitive, DL_XID_REQ primitive.