This category of identifiers contains the following error labels:
SLA CRC ERR SLA DRIVER ERR SLA EXCEPT ERR
SLA FRAME ERR SLA PARITY ERR SLA PROG ERR
SLA SIG ERR
Go back to the categories of Error Identifiers.
Error Description: SLA LINK CHECK CRC ERROR
This error indicates that the CRC checksum for a frame is not correct.
| Sense Data | The sense data consists of failure data that is analyzed by the Diagnostic Programs. The Status 1 and Status 2 fields are valid. |
Error Description: SLA LINK CHECK FAULT IN LASER DRIVE
This error indicates that the optics card has detected a fault in the transmit driver.
| Sense Data | The sense data consists of failure data that is analyzed by the Diagnostic Programs. The Status 1 and Status 2 fields are valid. |
Error Description: INTERNAL SERIAL LINK ADAPTER EXCEPTION
This error indicates that a PIO exception has been detected.
| Sense Data | The sense data consists of failure data that is analyzed by the Diagnostic Programs. Neither the Status 1 nor the Status 2 field is valid. |
Error Description: SLA LINK CHECK POSSIBLE LOST FRAME
This error is logged whenever a frame is lost. The detected error can be either a response time out or a send count error.
| Sense Data | The sense data consists of failure data that is analyzed by the Diagnostic Programs. If the Status 1 field is 0xFFFFFFFF and the Status 2 field is 0 , then a response time out occurred. If the Status 1 field is 0 and the Status 2 field is 0xFFFFFFFF , then a send count error was detected. |
Error Description: SLA BUFFER PARITY ERROR
This error is logged when the SLA detects either a parity error in the TAG register or a parity error in the data buffer.
| Sense Data | The sense data consists of failure data that is analyzed by the Diagnostic Programs. The Status 1 field and the Status 2 field are valid. |
Error Description: SLA PROGRAMMING CHECK
This error is logged when the SLA detects a program check. This error can be caused if the receiver did not map enough space for the message or if there is an incorrect tag as the first TOD clock work area.
| Sense Data | The sense data consists of failure data which is analyzed by the Diagnostic Programs. The Status 1 and Status 2 fields are valid. |
Error Description: SLA LINK CHECK SIGNAL FAILURE
This error is logged when the SLA detects a signal error in excess of 1 second.
| Sense Data | The sense data consists of failure data which is analyzed by the Diagnostic Programs. The Status 1 and Status 2 fields are valid. |