The Design Create toolbar contains the following buttons:
Route a Run: See Routing a Run | ||
Create an Offset Route: See Routing at an Offset of a Routable | ||
Route from Spline: See Route a Run Along a Spline | ||
Route thru a Pathway: See Route a Run Within a Pathway | ||
Break an Existing Run into Two Runs: See Breaking a Run | ||
Transfer Run to a Different Document: See Transfer Run to Another Document | ||
Flexible Tube Routing: See Routing Flexibles | ||
Flexible Bundle Routing: See Routing Flexible Bundles and Tubes | ||
Manage Local Slack: See Managing Local Slack | ||
Place Tubing Part: See Placing a Part on a Run | ||
Insulation Management: See Adding Insulation to a Part | ||
Loose Parts Management: See Adding and Managing Loose Parts |