Getting Started

The following short tutorial provides an introduction to Conduit Design, It is intended to give you a feel for the product's capabilities in a few step-by-step scenarios, listed below.

Entering the Workbench
Set Correct Working Units and Grid
Changing the Current Axis
Create a Run
Placing a Part on a Run
Saving Documents
Updating Documents
Using the Step Input Box and Construction Elements

 These tasks can be completed in about 15 minutes.
Certain functions will not work without setting up directory paths and options. The system administrator should refer to the tasks under Understanding Project Resource Management as well as platform dependent sample data in Finding sample data on various platforms.

The task Setting Up the Application (in the Customizing section) describes the various steps you have to take, and the order in which you have to do them, to set up Raceway & Conduit Design.