About the Equations Editor  

To improve the use of the Equations solving functions, the Equation Editor was modified. It is made up of two tabs: the Editors tab and the Options tab.

Editors tab

The Parse arrow is used to identify the variables of the set of constraints. It must be pushed before choosing input and output variables.
The left arrow is used to move variables from the Unknown parameters category to the Constant parameters one. 
The right arrow is used to move variables from the Constant parameters category to the Unknown parameters one. 
The Switch input/output arrow is used to swap the selected constant and unknown parameters.
  •  
 Viewer: enables you to enter the equations that you want to solve.
  •  
 Members of Parameters: see Engineering Knowledge Language (EKL).
  •  
 Constant parameters: Constant parameters: The value of constant parameters are set by you and are considered as constants by the solver. This value can be changed directly in the Value column by clicking twice (slowly) in the Value cell.
  •  
 Unknown parameters: The value of unknown parameters will be calculated after you press Apply. 

Options tab

Algorithm
  • Precision: enables you to define the precision of the results (i.e the number of decimal digits after the decimal point.)
  • Use the Gauss method for linear equations: accelerates the solve operation when working with linear equations.
Termination criteria
  • Maximal computation time (sec.): enables you to indicate the computation time. If the indicated time is equal to 0, the computation will last until a solution is found.
  • Show 'Stop' dialog: if checked, displays a "Stop" dialog box that will enable you to interrupt the computation.

  Solving a Set of Equations