dl_primitive |
Specifies the DL_BIND_ACK primitive. |
dl_sap |
Specifies the DLSAP address information associated with the bound
DLSAP. It corresponds to the dl_sap parameter of the
associated DL_BIND_REQ primitive, which contains part
or all of the DLSAP address. For the portion of the DLSAP address conveyed
in the DL_BIND_REQ primitive, this parameter contains
the corresponding portion of the address for the DLSAP that was actually bound. |
dl_addr_length |
Specifies the length of the complete DLSAP address that was bound
to the Data Link Provider Interface (DLPI) stream. The bound DLSAP is chosen
according to the guidelines presented under the description of the DL_BIND_REQ primitive. |
dl_addr_offset |
Specifies where the DLSAP address begins. The value of this parameter
is the offset from the beginning of the M_PCPROTO block. |
dl_max_conind |
Specifies whether a DL_CODLS stream will allow
incoming connection idications (DL_CONNECT_IND). If
the value is zero, the stream cannot accept any DL_CONNECT_IND messages; the stream will only accept DL_CONNECT_REQ. If the value is greater than zero, then this stream is a listening
stream, and indicates how many DL_CONNECT_IND's can
be pending at one time. |
dl_xidtest_flg |
Specifies the XID and test responses supported by the provider. Valid
values are:
- 0
- The DLS user will be handling all XID and TEST traffic.
- DL_AUTO_XID
- Automatically handles XID responses.
- DL_AUTO_TEST
- Automatically handles test responses.
- DL_AUTO_XID|DL_AUTO_TEST
- Automatically handles both XID and TEST responses.
|