The purpose of a nonquorum volume group is to have data continuously available even when there is no quorum. A quorum is a state in which 51% or more of the physical volumes in a group are accessible. You might want to change a volume group to nonquorum status in systems configured as follows:
In either configuration, if a disk failure occurs, the volume group remains active as long as there is one logical volume copy intact on a disk.
Both user-defined and rootvg volume groups can operate in nonquorum status, but the methods used to configure them as nonquorum and for recovery after hardware failures are different for user-defined and rootvg volume groups.
Attention: If a logical volume has its only copies residing on a disk that becomes unavailable, the information is not available to the user regardless of the quorum or nonquorum status of the volume group.
lslv -m LVName
To activate a nonquorum user-defined volume group, all of the volume group's physical volumes must be accessible or the activation fails. Because nonquorum volume groups stay online until the last disk becomes inaccessible, it is necessary to have each disk accessible at activation time.
If the user-defined volume group is not displayed in the list, follow step 3. Otherwise, follow step 2.
chvg -Qn VGName
chvg -Qn VGName
Note: Do not power on the system when a disk associated with the rootvg volume group is missing unless the missing disk cannot possibly be repaired. The Logical Volume Manager (LVM) always uses the -f flag to forcibly activate (vary on) a nonquorum rootvg; this operation involves risk. The reason for the forced activation is that the system cannot be brought up unless rootvg is activated. In other words, LVM makes a last ditch attempt to activate (vary on) a nonquorum rootvg even if only a single disk is accessible.
chvg -Qn rootvg