The following error messages can appear while using the kernel debug program:
A trace event was found that had an incorrect hookword type, and the traceback was terminated. This message is for your information only.
You entered a value that is outside of the numeric range of acceptable channel numbers. Enter the command again, selecting a channel in the range displayed in the prompt.
Ten consecutive pages were not in storage. To continue the search, enter Y (yes). To exit the search enter N (no).
The command was rejected because the data at the address you specified has been paged out of RAM to disk. Enter the command again with a data address that is currently in RAM.
The search passed over a page that was not in storage. Action is not required. This message is for your information only.
You specified a value that cannot be found or was not in real storage. Action is not required. This message is for your information only.
The breakpoint was not cleared because it is undefined or its segment is not currently addressable. Try to load the segment ID into a segment register with the set command.
A trace data structure is not currently paged into physical memory. Enter the command again later when the data structure is available.
A trace data structure is not currently paged into physical memory. Enter the command again later when the data structure is available.
A trace data structure is not currently paged into physical memory. Enter the command again later when the data structure is available.
A trace data structure is not currently paged into physical memory. Enter the command again later when the data structure is available.
A trace data structure is not currently paged into physical memory. Enter the command again later when the data structure is available.
The breakpoint is not set because you tried to set more than the maximum number of breakpoints allowed on the system. Clear at least one breakpoint before setting another breakpoint.
The command cannot run because you specified an address for the command that is in paged-out storage. Specify an address that is not in paged-out storage.
The command was unsuccessful because you did not specify all the required parameters. Enter the command again with the necessary parameters.
The command was unsuccessful because you specified a parameter that the debug program did not recognize. Check the spelling and syntax of the parameter you specified. Then, enter the command again with a valid parameter.