304.057 bytes

Product Information

Document ID: MIGR-47TJQH

Netfinity 1000 - Installing and removing ISA and PCI adapters

Applicable to: World-Wide

Installing or removing ISA and PCI adapters:
This section gives the procedure for installing an ISA or PCI adapter. If you want to remove an ISA or PCI adapter, reverse the order of the following steps. If you need to install an AGP adapter in the dedicated AGP slot connector, go to Installing or removing AGP adapters .

Notes 1. See Input/output connectors for an illustration of the expansion slots on the rear of the server. 2. If you install an ISA legacy adapter, set the resources to [ISA Resource]; this reserves the resources for the legacy adapter and prevents the BIOS from using these resources for the system or other adapters. If you remove an adapter, reassign the system resources as [Available] for ISA legacy adapters. See ISA Legacy Resources. 3. To install some adapters, especially full-length adapters, you might need to remove the bottom cover, the system board, and the front fan.

Notes Read Safety information. Read the documentation that comes with the option. Read Accessing the system board.

To install an ISA or PCI adapter:
1. Review the instructions that come with the adapter to determine if it must be installed in an ISA or PCI
expansion slot; otherwise, use any empty, bus-compatible slot.
2. Remove the server side cover (see Disconnecting cables and removing the side cover).
3. If necessary, remove the bottom cover (see Bottom cover).
4. Remove the screw and bracket.
5. Remove the appropriate expansion-slot cover:
a. Remove the expansion-slot screw on the top of the expansion-slot cover.
b. Slide the expansion-slot cover out of the server.
c. Store the expansion-slot cover in a safe place for future use.

6. Touch the static-protective package that contains the adapter to any unpainted metal surface on the server; then, remove the adapter from the package.
7. Install the adapter into the appropriate slot on the riser card.
You might have to remove the system board and the front fan in order to slide the adapter into the slot.
See Front fan and System board .

Note The components of a PCI adapter face down toward the system board, and the components of an ISA adapter face up. If a component in the server or on the adapter interferes with the installation, use another slot.

8. Install the bracket and the screw.

9. If you installed a network adapter that uses Wake on LAN or Alert on LAN, attach the cable from the riser
card to the adapter. See ISA and PCI adapters to locate the Wake on LAN or Alert on LAN connector. If you installed a modem and want to use Modem Wakeup, see ISA and PCI adapters to locate the Modem Wakeup connector on the riser card.

10. If you removed the bottom cover, the front fan, or the system board, replace them.

11. If necessary, connect any internal cables to the adapter. Refer to the documentation that comes with
the option.

12. If you installed an ISA legacy adapter, go to ISA Legacy Resources to assign system resources.

13. If you want to install or remove any other options, do so now. Otherwise, go to Completing the
installation .

	Search Keywords
	Document Category
	Date Created	12-05-99
	Last Updated	21-05-99
	Revision Date	26-05-2000
	Brand	IBM PC Server
	Product Family	Netfinity 1000
	Machine Type	8477
	Model	All
	TypeModel
	Retain Tip (if applicable)
	Reverse Doclinks and Admin Purposes