System Board Locations - 6268,6278,6288,6338,2173
(D) indicates the default jumper setting.
1 Fan 3 connector
2 Processor socket
3 DIMM socket 0
4 DIMM socket 1
5 Reserved connector
(Must be jumpered if present)
6 Alert on LAN
7 Power Switch/LED connector
8 Secondary IDE connector
9 Diskette drive connector
10 Primary IDE connector
11 Power connector
12 Battery
13 Fan 1
14 Wake on LAN connector
15 CMOS clear jumper
Normal Mode (D) = pins 1-2
CMOS Reset/Flash Recovery = pins 2-3
16 PCI 4 slot
17 PCI 3 slot
18 PCI 2 slot
19 PCI 1 slot
20 Internal Speaker connector
21 CD Audio connector
22 Telephony connector
23 Microphone connector
24 Serial 2 connector (COM B)
25 Line In connector
26 Line Out connector
27 Serial 1 connector (COM A)
28 Parallel connector
29 Display connector
30 USB connectors
31 Mouse/Keyboard connectors
Processor Speed Settings
Processor speed for the PC 300 type 6268, 6278, 6288/6388 and
Aptiva 2173 computers are fixed and are determned by the processor.
There are no settings required.
Diskette Write Access
Diskette Write Enable and Write Protect options are changed in the Setup Configuration.
Supported Memory Configuration (512 MB maximum)
DIMM sizes of 32 MB, 64MB, 128 MB, and 256 MB are acceptable.
Start filling DIMM socket 0, then 1.
Use 3.3V unbuffered 100 MHz SDRAM Non-Registered DIMMs only.
See > 'System Board Memory' for DIMM size, speed and type.
Please see the LEGAL - Trademark notice.
Feel free - send a for any BUG on this page found - Thank you.