Installing the UMA Program from the Hard Disk

Installing the UMA Program from the Hard Disk

To install the IBM Universal Management Agent Program from your computer's hard drive, use the preinstalled utility program:

1.  Double-click on the Start IBM Welcome icon.
2.  In the IBM Welcome Center window, click on Customize your system software in the left frame.
3.  In the screen that appears to the right, scroll down the window to the bottom. Then, click on Run the  Software Selection program from the hard drive.
4.  Click on Install Software. The install window appears.
5.  Scroll down the install window until Universal Management Agent 1.01 appears, then click on the  check box next to it.
6.  Click on the Install button at the bottom-right of the screen. The Software Selections Install Progress  window appears.
7.  Check to make sure that Universal Management Agent 1.01 is the only program to be installed, then  click on Install. The program installation screen appears.
8.  Using the information you gathered earlier, follow the instructions on the screen to select your  installation method and complete the installation.
9.  When the installation is complete, shut down and restart the operating system. The UMA programs  are ready to run. However, before starting the UMA program do the following:

•  See Chapter 4, 'Configuring Internet Explorer' to ensure your browser is configured  correctly for use with UMA.
•  If you installed UMA to be used with Microsoft SMS, see 'Configuring SNMP for UMA'  for additional configuration information.
•  If you installed UMA to be used with Tivoli Inventory, see 'Configuring Tivoli Inventory for UMA'  for additional configuration information.
•  If you installed UMA to be used with Tivoli NetView, see 'Configuring Tivoli NetView for UMA'  for additional configuration information.

Please see the LEGAL  -  Trademark notice.
Feel free - send a   for any BUG on this page found - Thank you.