PC 300 - 6277, 6287 - Pentium® II, Pentium® III - System Board Layout
1 Processor Socket
2 DIMM Socket 0
3 DIMM Socket 1
4 DIMM Socket 2
5 Power Switch Connector
6 LED Connector
7 Wake on LAN Connector
8 Primary (EIDE) Disk Drive Connector
9 Secondary (EIDE) Disk Drive Connector
10 Diskette Drive Connector
11 Power Connector
12 Wake on Ring Connector
13 CMOS Clear Jumper
14 Switch SW1
15 Battery
16 ISA Slot
17 CD-ROM Audio Connector
18 PCI 3 Slot
19 Speaker Connector
20 PCI 2 Slot
21 PCI 1 Slot
22 MIDI/Joystick Connector
23 Microphone In
24 Line Out
25 Headphone
26 USB Connectors
(top = USB2, bottom = USB1)
27 Mouse/Keyboard Connector
(top = Mouse, bottom = Keyboard)
28 Serial Connector
29 Parallel Connector
30 Display Connector
Jumper / Switch Settings
The following tables contain the jumper/switch setting information.
(D) indicates the default setting.
Please see the LEGAL - Trademark notice.
Jumper
Setting
Description
CMOS Reset
2-3
1-2 (D)CMOS reset.
Normal.
Pentium® III processors do not require speed settings.
For Pentium® III processors, you can ignore the speed settings.
Pentium® II - Processor Speed Switch Setting SW1 1-4
CPU
Switch
SettingsSW1-1
SW1-2
SW1-3
SW1-4
350 MHz
Pentium® II Off
Off
On
On
400 MHz
Pentium® II On
On
Off
On
450 MHz
Pentium® II Off
On
Off
On
Flash Boot Block Recovery Switch SW1-5
Flash Boot Block
SW1-5
Normal Mode
Off (D)
Recovery Mode
On
Diskette Write Access Switch SW1-6
Diskette Access
SW1-6
Write Enabled
Off (D)
Write Protected
On
Supported (384 MB max.) Memory Configurations
Any combination of 16, 32, 64, or 128 MB DIMM sizes, are acceptable.
Start filling at DIMM socket 0.
Use 3.3 V unbuffered Non-parity DIMMs only.
See 'System board memory' for DIMM size, speed and type.
Back to
Feel free - send a for any BUG on this page found - Thank you.