AT-IDE-EIDE (3.5 and 5.25-Inch) HDD Jumper Setting
AT-IDE HD Jumper setting (HD-pictures above)
Drive Jumper marked 1st for primary (Master) / 2nd is secondary (Slave) drive in machine.
- Type 1 170MB 340MB 424MB 850MB 2.0GB and 2.5GB
Drives with Tabs
- Type 2 170MB 270MB 363MB 540MB 727MB 1.2GB and 1.7GB
(Deskstar) Drives with Tabs
- Type 3 270MB and 540MB Drives with Jumpers
- Type 4 527MB Drive with Jumper
- Type 5 85MB and 170MB Drives with Tabs
- Type 6 129MB Drive with Jumper
- Type 7 170MB and 211MB Drives with Jumper
- Type 8 40MB and 80MB Drives with Jumpers
- Type 9 40MB Drive with Switches
- Type 10 80MB Drive with Switches
- Type 11 1GB Drive FRU P/N 06H6111
- Type 12 270MB 850MB and 1.2GB Drives (Level 2)
- Type 13 170MB Drive
- Type 14 1.6GB and 2.0GB Drives
- Type 15 1.6GB and 3.2GB Drives
- Type 16 3.24GB Drive (Deskstar 3)
Pin 1 = primary
Pin 2 = secondary
Pin 3 = autom. assign primary or secondary (if supported)
Pin 5 = disable write cache
Pin 4, 6 and 7 = reserved (do not connect)
- Type 17 850MB and 1.2GB Drives
- Type 18 1.2GB up to 3.2GB Drives used on 2136 Aptiva
CS = Cable select
DS = Drive select
SP = Slave present
Back to