Factory Installed Modem Card
NOTE: The factory-installed modem is a 33.6 Kbps modem
with a cable of microphone-in and speaker-out from system board.
+---+
|001| START
+---+
- Power off the system unit.
- Ensure that the modem is not configured with a conflicting COM port
and IRQ setting.
- Ensure that the communication software is configured with the correct
COM and IRQ settings (same COM port and IRQ as the modem).
- Ensure that all communication parameters (baud rate, data, stop and
parity bits) are properly configured and are identical on both sides.
- Connect the phone line to the LINE port of the modem card.
+---+
|002|
+---+
- Insert the diagnostic diskette into the diskette drive.
- Power on the system unit.
- Select Diagnostics menu.
- Select All Tests, then execute Modem test.
+---+
|003|
+---+
DOES THE MODEM PASS THE TEST? (YES, read ahead, NO, go to Step 004)
- Power off the system unit.
- Remove all adapter cards.
- Connect a hard disk drive withpre-loade Windows 95 inside.
- Power on the system unit.
- Perform the following steps under Windows 95.
NOTE: If an operating system other than MS Windows 95
is installed, the program screens and icons may differ from these
instructions.
1. Start MS Windows 95.
2. Select the Start icon.
3. Select Program, the select Accessories, Hyper Terminal.
4. Select the any a on-line service station, dial and connect to it.
+---+
|004|
+---+
CAN THE MODEM DIAL OUT AND CONNECT TO ANY BBS SUCCESSFULLY?
(YES, read ahead, NO, go to Step 005.)
- THe modem adapter functions normally.
- END.
+---+
|005|
+---+
- Ensure that Windows 95 is properly installed, then power off the
system unit.
- Plug the modem adapter card into a different ISA expansion slot.
- Go to Step 002.
- If the error symptom still remains, replace the modem adapter card.
- END.
Please see the LEGAL - Trademark notice.
Feel free - send a 
for any BUG on this page found - Thank you.