PC-300 / 6561, 6591 Pentium® II, Celeron - 233/266/333 MHz - System Board
1 CMOS Clear Jumper (J6C1)
2 Buzzer
3 Processor socket
4 Fan Connector for processor Fansink if required.
5 Reserved Jumper (EPROM protect) (J2A1)
6 DIMM socket 0
7 DIMM socket 1
8 Battery
9 Monitor connector
10 Parallel Port connector
11 Serial 1 connector
12 Serial 2 connector
13 Keyboard connector
14 Mouse connector
15 USB connectors
(top = USB1, bottom = USB2)
16 BOOT Block - Recovery Jumper (J7H1)
Jumper Settings J6C1, J7H1, J2A1
Please see the LEGAL - Trademark notice.
Jumper
Setting
Description
CMOS Clear
J6C1 2-3
1-2 (D) CMOS clear
Normal
Boot Block
Recovery J7H1 2-3
1-2 (D) Recovery
Normal
Reserved
Jumper J2A1 2-3 (D)
1, 2 Normal
Reserved
NOTE: Settings such as Diskette write enable
and Processor speed control are performed within the
Configuration/Setup Utility.
To start the Configuration/Setup Utility, see 'Setup Utility Program'.
Listed below are some of the settings in the Configuration/Setup Utility:
System Security
Advanced Setup
Supported Memory Configurations
Any combinations of 16MB, 32MB, 64MB or 128MB DIMM sizes, are acceptable.
Start filling DIMM socket 0, then 1. Use 3.3V unbuffered EDO DIMMs only.
Non-parity or ECC DIMMs are supported. Install only ECC DIMMs to enable ECC.
See > 'System Board Memory' for DIMM size, speed,
and type.
Supported Memory Configurations
total
MemoryBank 0
Bank 1
16MB
16MB-SDRAM
0
32MB
32MB-SDRAM
0
48MB
16MB-SDRAM
32MB-SDRAM
64MB
64MB-SDRAM
0
64MB
32MB-SDRAM
32MB-SDRAM
80MB
64MB-SDRAM
16MB-SDRAM
96MB
64MB-SDRAM
32MB-SDRAM
128MB
64MB-SDRAM
64MB-SDRAM
128MB
128MB-SDRAM
0
256MB
128MB-SDRAM
128MB-SDRAM
Back to
Feel free - send a for any BUG on this page found - Thank you.