Wake Up on Ring - LAN (300-700 Series)


  Wake Up on Ring: 300-700 Series


You can select settings so that, if the modem receives a call and the computer is in the suspend state, the computer 'wakes up' on the first ring, that is, it returns to full-power.

To select the Wake Up on Ring settings, feature, see Running Rapid Resume Manager


Network Settings
This applies only to computers linked to a network.

The Configuration/Setup Utility program includes settings that can be enabled and disabled to configure the network interface in the computer. These settings are:



Flash over LAN (Update POST/BIOS over Network)

NOTE: For local Flash (BIOS/VPD) update, see 'Flash (BIOS/VPD) Update Procedure'.

This setting is used to enable or disable the Flash over LAN feature. When the feature is enabled, the system programs, in the computer, can be updated remotely from a network server. If the administrator password is set in the computer, it does not have to be entered by the server.

To access the Flash over LAN setting:
  1.  Start the Configuration/Setup Utility program. See 'Setup Utility Program'
  2.  Select System Security
  3.  Select POST/BIOS Update from the Configuration/Setup Utility program menu.
  4.  To enable Flash over LAN, select Enabled. To disable Flash over LAN, select Disabled.
  5.  Press Esc twice to return to the configuration/Setup Utility program menu.
  6.  Before you exit from the program, select Save Settings from the Configuration/Setup Utility program menu.
  7.  To exit from the Configuration/Setup Utility program, press Esc and follow the instructions on the screen.


Wake on LAN

This setting is used to enable or disable the IBM-developed Wake on LAN feature. This feature makes it possible for the computer to be turned on remotely by a network server. Remotely network management software must be used in conjunction with this feature.

To access the Ake on LAN (WOL) setting:

  1.  Start the Configuration/Setup Utility program. See 'Setup Utility Program'
  2.  Select Advanced Power Management
  3.  Select AutomaticPower On from the program menu.
  4.  Select Wake on LAN from the Automatic Power On menu.
  5.  To enable Wake on LAN, select Enabled. To disable Wake on LAN, select Disabled
  6.  Press Esc until you return to the Configuration/Setup Utility program menu.
  7.  Before you exit from the program, select Save Settings from the Configuration/Setup Utility program menu.
  8.  To exit from the Configuration/Setup Utility program, press Esc and follow the instructions on the screen.

Back to  Jump to TOP-of-PAGE

Please see the LEGAL  -  Trademark notice.
Feel free - send a Email-NOTE  for any BUG on this page found - Thank you.