Menu Options Default Value
System Group
System Identification and Version Information
System Identification String None
Config and Overlay Version
BIOS Version String
MP Sec. Version 1.1
System Processor Status
1st Processor Status, Module 1 No Failures detected
2nd Processor Status, Module 1 No Failures detected
3rd Processor Status, Module 2 No Failures detected
4th Processor Status, Module 2 No Failures detected
System Performance
Power-on Speed Fast
Secondary IOAPIC control Disable
Memory Subsystem
Base Memory Option 640 KB
Shadowing ISA ROMs Options (Menu)
Extended Memory Options (Menu)
Peripheral Configuration Group
Automatic Configuration Enable
Onboard Disk Controllers
Onboard Floppy Controller Enable
Onboard Communications Devices
Serial Port 1 Configuration Serial Port 1 Address and IRQ
Serial Port 2 Configuration Serial Port 2 Address and IRQ
Parallel Port Configuration Parallel Port Address and IRQ
Parallel Port Mode Parallel port mode
Parallel Port DMA Valid only with ECP mode
Floppy Subsystem Group
Floppy drive A Options Size and capacity
Floppy drive B Options Size and capacity
Language Support Group
Language Support options Languages supported
Keyboard/Mouse Subsystem Group
NumLock Options Off at Boot
Typematic Speed Auto
Mouse Control Option Autodetected
Console Redirection
COM port for redirection Disable
Baud rate 115.2k
Hardware Flow Control None
Terminal Type ANSI
Security Subsystem
Administrator Password Disable
User Password Disable
Hot-Key Option Disable
Lockout Timer 10 min.
Secure Boot Mode Disable
Video Blanking Disable
Boot Subsystem Group
First Startup Drive Diskette Drive
Second Startup Drive Hard Disk 0
Third Startup Drive Boot disabled
Fourth Startup Drive Boot Network
Display "<F1> for Setup" Enable
message during POST
Require user interaction on Disable
POST errors
SCSI ROM BIOS Options Group
SCSI A ROM scan Enable
SCSI B ROM scan Enable
LCD
LCD Enable
LC Display String Before OS Boot Default
Management Subsystem
Temperature/Voltage Limit Control (Menu)
A to D Channel Enable Switch (Menu)
Speaker Options Enable
Scan user flash area Disable
System Management Options
System Management Mode Enable
SMM time stamp Source POST capture
Event Logging Disable
Reserve VGA resources Reserve VGA memory
Options Default Value
Flash EEPROM Revision Level _______________________
System Board Identifier _______________________
System Serial Number _______________________
BIOS Date _______________________
Video Setup
Video Controller SVGA
Video Memory 512 KB
The following table shows the defaults for system memory and extended
memory that was shipped with the system.
Option Default
System Memory 640KB
Extended Memory 360KB
Bank 1 socket 1 16MB (Non RAID and Disk Array Models)
32MB (Open bay models)
Bank 1 socket 2 16MB (Non RAID and Disk Array Models)
32MB (Open bay models)
Bank 1 socket 3 16MB (Non RAID and Disk Array Models)
32MB (Open bay models)
Bank 1 socket 4 16MB (Non RAID and Disk Array Models)
32MB (Open bay models)
Bank 1 socket 5 16MB (Disk Array Models)
Bank 1 socket 6 16MB (Disk Array Models)
Bank 1 socket 7 16MB (Disk Array Models)
Bank 1 socket 8 16MB (Disk Array Models)
Bank 2 socket 1
Bank 2 socket 2
Bank 2 socket 3
Bank 2 socket 4
Bank 2 socket 5
Bank 2 socket 6
Bank 2 socket 7
Bank 2 socket 8
Please see the LEGAL - Trademark notice.
Feel free - send a 
for any BUG on this page found - Thank you.