SCSI Diagnostics (Dock I / 3545)
SCSI Diagnostics (Dock I)
The SCSI diagnostics help you troubleshoot SCSI adapter and
device problems through a series of menus.
The diagnostics are provided on the Dock I Option Diskette.
Some SCSI devices might be shipped with diagnostics However,
you must use the option diskette shipped with Dock I to test the SCSI
controller and SCSI devices.
NOTE:
- In the diagnostics, the built-in SCSI controller is regarded as an
adapter. If the diagnostics detect any adapter problems,
replace the main board of the Dock I.
- If the SCSI devices are not connected to the Dock I, the built-in
SCSI controller is disabled. You cannot run the SCSI diagnostics.
The below procedures summarizes the major steps.
SCSI Diagnostics Utility Program Procedure
- Start the utility program.
- Select the SCSI adapter to be scanned.
- Select the SCSI device to be tested.
- Select a test option from the SCSI fixed/removal
drive menu. The options are:
- Adapter Diagnostics
- Send Device Diagnostics
- Test Unit Ready
- Read Test
- Read/Write Test (if you have a fixed disk drive)
- Low-Level-Format Drive.
Back to 
Please see the LEGAL - Trademark notice.
Feel free - send a 
for any BUG on this page found - Thank you.