FRU P/N OPT P/N
-----------------------------------------------------------
PCIRAID Controller 75H9011 94G5884 (two channel)
DRAM SIMM 4MB 60G2175
DRAM SIMM 32MB xxxxxxx
Battery Backup Unit xxxxxxx
-----------------------------------------------------------
PCIRAID Controller (DAC960PL) Specifications
CPU Intel® i960JF RISC 32-bit microprocessor
Memory ° DRAM Module Type 72-pin SIMM, 70ns (or faster)
° Minimum 2 MB
° Optional 4, 8, 16 or 32 MB (n x36)
° Cache Type
- Write selectable, Write Through or Write Back
- Read always enabled
Firmware ° ROM Type Flash EEPROM 256x8 boot-sectored
° BIOS Executed from DRAM (Shadow RAM)
PCI ° I/O Processor Mylex 189206 ASIC
° Bus Type 32-bit, 33MHz, PCI Local Bus
° Mode Bus Master
° Transfer Rate Up to 132 MB/second (burst)
SCSI ° I/O Processors 53C720 one per channel
° Bus Type 8 or 16-bit Fast/Wide SCSI-2 compliant
° Transfer Rate Up to 20MB/second per channel
Up to 60MB/second 3 channels
RAID ° Levels supported
- RAID 0, Striping
- RAID 1, Mirroring
- RAID 5, Parity
- RAID 0+1, Striping and Mirroring
- JBOD, Single-drive control
Electrical ° Input Power (Supply currents assume drives providing
term power (5Vdc at 5%)
- 5V 2.5 Amp. (w/4MB memory)
- 5V 3.5 Amp. (w/16MB memory)
Environmental ° Temperature
- Operating 5°C to 55°C
- Storage -60°C to +150°C
° Humidity (non condensing)
- Operating 20% to 90% rh
- Non Operating 20% to 90% rh
Dimensions ° Length 12.5 inches
° height 4.19 inches
CAUTION When you remove or install the PCIRAID controller board, the battery backup module continues to
provide it with power. To prevent damaged to the board, do not allow anything metal to touch its components or gold edge connectors.
The PCIRAID Adapter uses a 32-bit RISC-based microprocessor, ASIC logic array, and a dedicated
read/write cache memory to reduce the host system CPU load and to increase disk I/O throughput (up to 60MB/sec. 3-channel controller).
Standard on-board memory is a 72-pin, 36-bit 70ns (or faster) DRAM SIMM module, of either 2, 4, 8, 16 or 32 MB size.
The default SCSI address for the PCIRAID controller is target ID 7.
If you connect SCSI devices to an internal channel on the PCIRAID, you should not connect
any devices to its corresponding external channel. The total SCSI bus length must not exceed three meters.
Automated RAID Functions
Please see the LEGAL - Trademark notice.
Feel free - send a for any BUG on this page found - Thank you.