Undetermined Problems - Netfinity 5600 - Type 8664


Undetermined Problems

You are here because the diagnostic tests did not identify the failure, the Devices List is incorrect, or the system is inoperative.

Notes:

  1.  If you suspect a software mismatch is causing failures (solid or intermittent), be sure to see 'Resolving configuration conflicts'.
  2.  A corrupt CMOS can cause undetermined problems.


Check the LEDs on all the power supplies.
If the LEDs indicate the power supplies are working correctly, return here and do the following:

  1.  Power-off the computer.
  2.  Be sure the system is cabled correctly.
  3.  Remove or disconnect the following (one at a time) until you find the failure
     (power-on the computer and reconfigure each time).

    Note: Minimum operating requirements are:

     Power supply
     Processor board, use switch 3 on switch block 2 on the processor board to bypass the power switch button.
     Verify that the power connectors J11 and J14 are installed correctly at both ends.

     System Board
     Memory Module kit Minimum requirement = 1 bank of 128 MB DIMM

  4.  Power-on the computer. If the problem remains, suspect the following FRUs in the order listed:



Note: If the problem goes away when you remove an adapter from the system, and replacing that adapter does not correct the problem, suspect the system board then the processor.


Back to  Jump to TOP-of-PAGE

Please see the LEGAL  -  Trademark notice.
Feel free - send a Email-NOTE  for any BUG on this page found - Thank you.