Completing the Tower Model Installation - Netfinity 5600 - Type 8664


Completing the Tower Model Installation.

To complete the installation for the tower model:

  1.  Install the left-side cover, if it was removed.
  2.  Install the trim bezel, if it was removed.
  3.  Install the server door, if it was removed.
  4.  Restart the server.
  5.  Update device records and reconfigure the server (see 'Updating device records and reconfiguring the server').

    To install the server left-side cover:

     
    1 Slots
    2 Left-side cover

    1.  Align the left-side cover -2- with the left side of the server,  about 25 mm (1 inch) from the front of the server; place the bottom of the left-side cover  on the bottom rail of the left-side side of the chassis.
    2.  Insert the tabs at the top of the cover into the slots -1- at the top of the server side.
    3.  Hold the cover against the server and slide the cover toward the front of the server until the cover clicks into place.

    To install the trim bezel:

     
    1 Trim bezel
    2 Slots (hidden by bezel)

    1.  Place the tabs at the bottom edge of the trim bezel -1- in the slots -2- at the bottom front of the server.
    2.  Press the top of the bezel toward the server until the bezel clicks into place.

    To install the server door:

     
    1 Flange
    2 Server door

    1.  Set the door -2- on the bottom hinge.
    2.  Press the flange -1- downward while pressing the top of the door toward the server,  until the flange connects with the top hinge.
       Release the flange.

  6.  Close and lock the server door.

      -Attention- Be sure to maintain a clearance of at  least 127mm (5 inches) on the front and rear of the server to allow for air circulation.

  7.  If you disconnected any cables from the back of the server, reconnect the cables; then, plug the power  cords into properly grounded electrical outlets.

    Note: If necessary, see 'Input/output connectors and expansion slots' for connector locations.

Back to  Jump to TOP-of-PAGE

Please see the LEGAL  -  Trademark notice.
Feel free - send a Email-NOTE  for any BUG on this page found - Thank you.