Moving a Tape Cartridge from a Tape Drive to a Cell
Note: Before moving a tape cartridge from a tape drive to another location, the
tape must first be unloaded.
The tape can be unloaded by issuing a REWIND/UNLOAD command from the host computer.
Also, you can manually unload the tape cartridge by reaching through the front door and pressing the
Unload button.
(For more information about manually unloading a tape cartridge, see 'Manually Removing a Tape Cartridge'.)
Starting from:
IBM XXX7 X.XX x
DIAG OFFLINE
A: DLT7000 VNN y1
B: DLT7000 VNN y2
CHANGE MODE
->MOVE CARTRIDGE
DLT DIAGNOSTIC
CONFIDENCE TEST
REMOTE DIAGS
DRVLDULD
COMM TEST
MAINTNANCE MENU
SELECT SOURCE
->Storage Cell ?
Drive ?
SELECT SOURCE
->Drive A ?
Drive B ?
For tape libraries with two tape drives, use the CYCLE and MENU key to switch between drive A and drive B.
SELECT DEST
->Storage Cell ?
Drive ?
SELECT DEST
Cartridge 0 ?
Press the CYCLE key to increase the storage cell number from 0 through 14.
Press the MENU key to decrease the storage cell number trom 14 through 0.
To void the pending move operation, press the MENU key when the arrow is pointing at Drive A.
To run the move operation, press the SELECT key. The following menu is shown on the operator panel.
Press select to
execute move
From Drive y
To Element xx
MOVE
From Drive y
MOVE
To Element xx
Please see the LEGAL - Trademark notice.
Feel free - send a for any BUG on this page found - Thank you.