Moving a Cartridge from a Cell to a Tape Drive
Starting from:
IBM XXX7 X.XX x
DIAG OFFLINE
A: DLT7000 VNN y1
B: DLT7000 VNN y2
CHANGE MODE
->MOVE CARTRIDGE
DLT DIAGNOSTIC
CONFIDENCE TEST
REMOTE DIAGS
DRVLDULD
COMM TEST
MAINTNANCE MENU
SELECT SOURCE
->Storage Cell ?
Drive ?
SELECT SOURCE
Cartridge 0 ?
Press the CYCLE key to increase the storage cell number from O through 14.
Press the MENU key to decrease the storage cell number from 14 through 0.
SELECT DEST
->Storage Cell ?
Drive ?
Press the CYCLE key to move the arrow from Storage Cell to Drive.
SELECT DEST
->Drive A ?
Drive B ?
For tape libraries with two tape drives, use the CYCLE key to switch between drive A and drive B.
To void the pending move operation, press the MENU key when the arrow is pointing at the element 0.
To run the move operation, press the SELECT key.
The following menu is shown on the operator panel.
Press select to
execute move
From Element xx
To Drive y
MOVE
From Element xx
MOVE
To Drive y
After the move operation is finished, press the MENU key.
The DIAG OFFLINE menu is shown on the operator panel, and you can perform additional operations.
Please see the LEGAL - Trademark notice.
Feel free - send a for any BUG on this page found - Thank you.