Tape Library Start MAP

Tape Library Start MAP

Leave the tape library power on.
If the library power is off, turn the power on.
Ensure that all customer applications have completed operation.

Step 1

Note and record the following:

•  Are there any obvious power light or error light problems?
  •  Are all three fans operating?
  •  Is the operator panel lit?
  •  Does the operator panel display have poor contrast?
  •  Do the control keys function properly?
  •  Is the 5 V light on? (The 24 V light may be on or off; see the lights at the rear of the library.)
  •  Is the controller fault light (red) on?

•  Does the operator panel display any messages or error codes?
•  Does the host console display any messages, error codes, or sense data?
•  Has the customer made any comments?

Step 2

Open the front door of the tape library and remove the magazine.
Go to the 'Initial Inspection Checklist', then go to (below) Step 3.

Step 3

Did you note any power or display problems or is the library controller fault light on?

Yes	Go to 'Power Problems and Fault Light MAP'.
No	Go to Step 4.

Step 4

Did you find and fix an observed library or tape drive problem?

Yes	Go to 'Library Exerciser, Diagnostic, and Fix Verify Selections' on
	page 35, or 'DLT7000 Tape Drive Diagnostic and Fix Verify Selections'.
No	Go to Step 5.

Step 5

Did the operator panel indicate that a drive requires service, or did you
observe a possible drive problem (such as blinking lights or a stuck cartridge),
or did the host error data or message indicate a tape drive problem?

Yes	Go to 'DLT7000 Tape Drive MAP'.
No	Go to Step 6.

Step 6

Did you observe a possible base library problem during the inspection, or did
the bar code reader have difficulty reading external bar code labels on the
tape cartridge?

Yes	Go to 'Base Library Problem MAP'.
No	Go to Step 6.

Step 7

Did you have a SCSI or interface problem affecting one or more devices?

Yes	Go to 'SCSI or Interface MAP'.
No	Go to 'Problem and Error Code Recreation MAP'.

Please see the LEGAL  -  Trademark notice.
Feel free - send a   for any BUG on this page found - Thank you.