Installing the ServeRAID WIN32-Based Program

Installing the ServeRAID WIN32-Based Program

This section provides instructions for installing the ServeRAID WIN32-Based program.

Before you begin the installation.

•  Be sure that the ServeRAID adapter or controller is physically installed, properly cabled, and configured.
•  Be sure that the network operating system is installed and functional.
•  If the network operating system is Windows NT, you can use the ServeRAID WIN32-Based program remotely in the  client/server mode or locally in stand-alone mode.
   Use the instructions in this section and in 'Installing ServeRAID Device Drivers' to install the ServeRAID files.
•  The ServeRAID adapters and controllers do not support Windows 95.
   However, you can run the WIN32-Based program remotely on a Windows 95 client attached to a remote server  running the OS/2, NetWare, Windows NT, UnixWare, or OpenServer operating system.
   Use the instructions in this section to install the WIN32-Based program on the Windows 95 client.
•  If the network operating system is OS/2, NetWare, OpenServer, or UnixWare, you must run the ServeRAID WIN32-Based  program remotely, in the client/server mode.

   Other requirements for this environment include:

  •  A Windows NT or Windows 95 client running the IBM ServeRAID WIN32-Based program
     Use the instructions in this section to install the WIN32-Based program.
  •  A network adapter with proper cabling for access to the remote systems
  •  The TCP/IP networking protocol installed on both the local and remote systems
  •  The ServeRAID device driver and background-server component installed on the remote system
     Refer to 'Installing ServeRAID Device Drivers' for more information.

To install the ServeRAID WIN32-Based program:

1.  Turn on the system and allow Windows NT or Windows 95 to start.
2.  Insert the IBM ServeRAID Configuration CD  into the CD-ROM drive.
3.  Click on Start, click on Run; then, type the following:

     z:\programs\disk3\setup

   Note: The z  represents the letter assignment for the CD-ROM drive that contains the ServeRAID CD.

4.  Press Enter; then, follow the instructions that appear on the screen to complete the installation.

Please see the LEGAL  -  Trademark notice.
Feel free - send a   for any BUG on this page found - Thank you.