Server controls
Power Switch
Press this switch to turn the server on or off.
- Attention - Do not
turn off the server if a drive in-use light is on. This might damage
the information stored on a hard disk or on a diskette.
When the power is on, there is a period of time during the power-on
self-test (POST), a short test that occurs when the server is turned on, when
a single touch of the power switch will not turn off the power.
If power must be turned off during POST, press and hold the power switch
for 5 seconds or disconnect the power cord.
After POST, the power switch works normally, unless the server is in a
hang condition. If the server is in a hang condition, press and hold the
power switch until the power turns off.
CD-ROM Eject/Load Button
Push this button to release a CD from the CD-ROM
drive. See CD-ROM Drive.
for additional information about the
CD-ROM drive controls and indicators.
Diskette Eject Button
Push this button to release a diskette from the diskette drive.
Please see the LEGAL - Trademark notice.
Feel free - send a for any BUG on this page found - Thank you.