Installing the QLC2100F Device Driver

Installing the QLC2100F Device Driver

Perform the following steps to install the QLC2100F driver in a previously installed SCO UnixWare 7.0 system.

1.  Make sure you have root privileges.
2.  Enter the following text at the prompt to run the PKGADD program:

     pkgadd -d diskette1

    The following prompt appears:

     Insert diskette into Floppy Drive 1.
     Type (go) when ready,
     or (q) to quit: (default: go)

3.  Insert the Netfinity Fibre Channel SCO UnixWare HBA driver diskette for UnixWare 7 into your diskette drive  and press Enter (go). You will see the following screen:

    Installation in progress. Do not remove the diskette.

       The following packages are available:
         1 QLC1020 QLogic QLA1040/1041 IHV HBA
                         (i386) 1.16
         2 QLC1240 QLogic QLA1240/1240D IHV HBA
                         (i386) 1.0
         3 QLC2100 QLogic QLA2100/2100F IHV HBA
                         (i386) 1.06
       Select packages(s) you wish to process (or 'all'
       to process all packages). (default: all) (?,??,quit):
    

4.  When prompted to select a driver package, type 3 and press Enter to install the QLC2100F driver.

    When the driver is installed, the following prompt appears:

       Installation of QLogic QLA2100/2100F IHV HBA (QLC2100)
       was successful.
       Insert diskette into Floppy Drive 1.
       Type (go) when ready,
            or (q) to quit: (default: go)
    

5.  Type q and press Enter to exit the installation program.
6.  Remove the Netfinity Fibre Channel SCO UnixWare HBA driver diskette for UnixWare 7 driver diskette.
7.  Restart the system to load the driver.

Please see the LEGAL  -  Trademark notice.
Feel free - send a   for any BUG on this page found - Thank you.