Configuration/Setup Utility
For most configurations, the server will operate using the
default system settings. You need to change the settings
only to resolve configuration conflicts or to enable or
change device functions.
When you want or need to change the default settings, the
Configuration/Setup utility program provides a convenient
way to display and change the settings.
After you run and exit the Configuration/Setup utility
program, configuration information is stored in nonvolatile
random-access memory (NVRAM). While the server is
powered off, the configuration information remains
available for the next system startup.
Always run the Configuration/Setup utility program if you
add or remove any hardware option, or if you receive an
error message instructing you to do so. Review this
chapter and the information that comes with the option
before making changes. Also, record the current settings
before making any changes.
To start the Configuration/Setup utility program:
The Configuration/Setup utility main menu appears. For information about the menus, see 'Configuration/Setup Utility Usage'.
NOTE: If you enter a power-on password and an administrator password has been set, a limited menu appears on the screen. To access the full Configuration/Setup utility menu, you must enter the administrator password.
The Diagnostic Utility main menu appears. For information about running the system diagnostics, see 'Diagnostic Test Programs'.
Please see the LEGAL - Trademark notice.
Feel free - send a for any BUG on this page found - Thank you.