Type 3523 Fibre Channel Hub and GBIC

Type 3523 Fibre Channel Hub and GBIC

•  Verifying GBIC and Cable Signal Presence
•  Features
•  Description
•  Applications and Configurations
•  Power On Systems Check - Fibre Channel Hub
•  Locations
  •  Fibre Channel Hub Rack Installation
  •  Installing the GBIC
  •  Removing the GBIC
•  Symptom-to-FRU Index

General Checkout

Installation and operational problems in an arbitrated loop environment are typically caused by one of the following:

•  Faulty cabling or cable connector
•  Incorrect cable length
•  Faulty GBIC
•  Invalid Fibre Channel signaling from the host bus adapter (HBA) or disk array
•  Device driver or microcode conflicts between the HBAs and other devices.

Port Status LEDs

The hub provides two status LEDs for each port. Use these LEDs to help you quickly diagnose and recover from problems.

The upper, green LED is lit when an operational GBIC is installed. The lower, amber LED is lit when the port is in the bypass mode. In the bypass mode, a port is disabled, which prevents erratic signals or data from disrupting loop activity. The bypass mode could be triggered by the loss of valid signal or by a GBIC fault. The combination of green and amber LEDs indicate the four following states.

Green LED	Amber LED	Port State
Off	Off	No GBIC Installed
On	Off	Operational GBIC, Valid Signal
Off	On	Faulty GBIC, Port Bypassed
On	On	Operational GBIC, No Valid Signal, Port Bypassed

Please see the LEGAL  -  Trademark notice.
Feel free - send a   for any BUG on this page found - Thank you.