Installing IPSSEND and IPSMON for OS/2, Windows NT, or NetWare

Installing IPSSEND and IPSMON for OS/2, Windows NT, or NetWare

To install these programs for OS/2, Windows NT, or NetWare:

1.  After you create an IBM ServeRAID Command Line Programs Diskette  using Diskette Factory or by  downloading the image from the IBM Support Page on the World Wide Web, start the server.
2.  After the operating system loads, insert the IBM ServeRAID Command Line Programs Diskette  into the diskette drive.
3.  If you are using NetWare, go to (below) step 5. If you are using Windows NT or OS/2, create an  IPSADM directory on your hard disk drive.  To do this, go to the operating system command prompt and type:

   md c:\ipsadm

   NOTE:
    1. The c represents the drive where OS/2 or Windows NT is installed.
    2. If you installed the Administration and Monitoring Program files, you already created this directory.

4.  Press Enter.
5.  Copy the IPSSEND.EXE file to your hard disk drive by typing one of the following at the command prompt:
   •  For OS/2, type:

     copy a:\os2\ipssend.exe c:\ipsadm

   •  For Windows NT, type:

     copy a:\nt\ipssend.exe c:\ipsadm

   •  For NetWare, type:

     copy a:\netware\ipssend.nlm c:\nwserver

   NOTE:  br  1. The a represents the drive assignment for the diskette drive that contains the ServeRAID diskette.
    2. The c represents the drive where OS/2, Windows NT, or NetWare is installed.
    3. These instructions assume that you installed NetWare in the NWSERVER directory.

6.  Press Enter, then, copy the IPSMON.EXE file to your hard disk drive by typing one of the following at the  command prompt:
   •  For OS/2, type:

     copy a:\os2\ipsmon.exe c:\ipsadm

   •  For Windows NT, type:

     copy a:\nt\ipsmon.exe c:\ipsadm

   •  For NetWare, type:

     copy a:\netware\ipsmon.nlm c:\nwserver

   NOTE:
    1. The a represents the drive assignment for the diskette drive that contains the ServeRAID diskette.
    2. The c represents the drive where OS/2, Windows NT, or NetWare is installed.
    3. These instructions assume that you installed NetWare in the NWSERVER directory.

7.  Press Enter, then, refer to 'Starting the ServeRAID Administration and Monitoring Program'  for information to start and use the IPSSEND and IPSMON programs.

Please see the LEGAL  -  Trademark notice.
Feel free - send a   for any BUG on this page found - Thank you.