Installing ServerRAID Device Drivers for OpenServer
To use the ServeRAID Administration and Monitoring Program with SCO, you must first install the WIN32-Based
version of the Administration and Monitoring Program on a Windows NT or Windows 95 client.
Then, attach the Windows NT or Windows 95 client to the same network as the OpenServer systems that
contain the ServeRAID adapters or controllers.
Finally, you must install the ServeRAID device driver and background-server component for OpenServer.
The background-server component for OpenServer installs automatically when you use the instructions in this chapter
to install the ServeRAID OpenServer device driver. This component enables the OpenServer system to act as the
TCP/IP interface for the remote WIN32-Based Program.
(See 'ServeRAID Programs for Windows NT and Windows 95' for more information.)
Installing the Files for OpenServer: Before you begin the installation,
review the following information:
link Stp=ips(0,1,2,0)
The numbers in parentheses represent the Host Adapter Number, the Bus Number, the SCSI ID, and the LUN respectively.
Adding BTLD at Boot Time: To install the ServeRAID device driver for OpenServer,
Version 5.0.X:
link
ipsraid
While the installation program copies the files, one or both of the following messages might appear:
Messages
1. Extracting BTLD distribution for ipsraid... /etc/uadmin getdev b ips: No such device (error 19)
2. dynamic linker: dlvr_audit: Cannot open /dev/zero for file /lib/libprot.so.1
You can ignore Message A, no action is required. But if Message B appears, you must press Enter when prompted to continue the installation.
For additional information about adding a BTLD at boot time, refer to 'Using Boot-Time Loadable Drivers' in the
SCO OpenServer Handbook.
Adding BTLD after the Initial Installation
installpkg
ipsraid
cd /etc/conf/cf.d
./link_unix
The UNIX kernel has been rebuilt. Do you want this kernel to boot by default?
To continue, enter: y
The system backs up the old kernel by moving /UNIX to /UNIX.OLD.
Installing the Files for OpenServer 5.0.0
To install files for OpenServer 5.0.0 using an IDE CD-ROM drive:
restart ahslink="ATAPI ipsraid" Srom=wd(0,0,0,0)
The fields for the ATAPI CDROM are:
Srom=wd(c,d,l,b) where:
c = primary (0) or secondary (1) IDE/EIDE controller
d = master (0) or slave (1) device
l = LUN of device (always 0 with ATAPI or "wd" driver)
b = BUS of device (always 0 with ATAPI or "wd" driver)
Installing the Files for OpenServer 5.0.2 and 5.0.4: To install files for OpenServer Versions 5.0.2 or
5.0.4 using an IDE CD-ROM drive:
restart link=ipsraid Srom=wd(0,0,0,0)
NOTE: The ATAPI BTLD (which includes the wd driver) is included in OpenServer 5.0.2 and 5.0.4.
The fields for the ATAPI CDROM are:
Srom=wd(c,d,l,b) where:
c = primary (0) or secondary (1) IDE/EIDE controller
d = master (0) or slave (1) device
l = LUN of device (always 0 with ATAPI or "wd" driver)
b = BUS of device (always 0 with ATAPI or "wd" driver)
Please see the LEGAL - Trademark notice.
Feel free - send a for any BUG on this page found - Thank you.