Installing the ServeRAID WIN32-Based Program

Installing the ServeRAID WIN32-Based Program

This section provides instructions for installing the ServeRAID WIN32-Based program.

Before you begin the installation.

•  Be sure that your ServeRAID adapter or controller is physically installed, properly cabled, and configured.
•  Be sure that your network operating system is installed and functional.
•  If your network operating system is Windows NT, you can use the ServeRAID WIN32-Based program remotely  in the client/server mode or locally in stand-alone mode.
•  The ServeRAID adapters and controllers do not support Windows 95. However, you can run the WIN32-Based  program remotely on a Windows 95 client attached to a remote server running the OS/2, NetWare, Windows NT,  UnixWare, or OpenServer operating system. Use the instructions in this section to install the WIN32-Based  program on the Windows 95 client.
•  If your network operating system is OS/2, NetWare, OpenServer, or UnixWare, you must run the  ServeRAID WIN32-Based program remotely, in the client/server mode.

   Other requirements for this environment include:

  •  A Windows NT or Windows 95 client running the IBM ServeRAID WIN32-Based program

     Use the instructions in this section to install the WIN32-Based program.

  •  A network adapter with proper cabling for access to the remote systems
  •  The TCP/IP networking protocol installed on both the local and remote systems
  •  The ServeRAID device driver and background-server component installed on the remote system
     Refer to 'Installing ServeRAID Device Drivers' for more information.

   If you are using Windows NT, use the installation instructions and ServerGuide CDs provided with your  server to install the Administration and Monitoring program.
   If you want to install the program on a remote Windows 95 client, use the ServerGuide Diskette Factory to create an  IBM ServeRAID Administration and Monitoring Diskette, then, use the instructions in this section to install the  Administration and Monitoring program.

1.  Turn on the system and allow Windows NT or Windows 95 to start.
2.  Insert the IBM ServeRAID Administration and Monitoring Diskette into the diskette drive.
3.  Click on Start, click on Run, then, type the following:

     a:\setup

   NOTE: The a represents the letter assignment for the diskette drive.

4.  Press Enter, then, follow the instructions that appear on the screen to complete the installation.

Please see the LEGAL  -  Trademark notice.
Feel free - send a   for any BUG on this page found - Thank you.