ServeRAID IPSMON Program (Using)
When you start this monitoring program, it immediately begins polling all ServeRAID adapters
and controllers for specific conditions. If a condition being monitored is found, this program
logs a message to the monitor, to a file, or to both the monitor and a file.
The IPSMON program uses command-line parameters to determine where to log the messages.
If you need help, you can type the IPSMON -? command for a list of valid parameters.
If you start this program without any command-line parameters, the IPSMON program will log
the messages to the IPSMON.LOG file, and the messages will not appear on the monitor.
The valid parameters for IPSMON are:
After you start the IPSMON program, the program will continuously poll the ServeRAID adapters
and controllers until you take one of the following actions:
The IPSMON program can log the following messages, based on the required condition.
Information Messages:
<Date and Time> INF000:A1C-SID
- no errors detected
<Date and Time> INF001:A1C-SID
- rebuild started
<Date and Time> INF002:A1C-SID
- rebuild completed
<Date and Time> INF003:A1C-SID
- synchronization started
<Date and Time> INF004:A1C-SID
- synchronization completed
<Date and Time> INF005:A1C-SID
- migration started
<Date and Time> INF006:A1C-SID
- migration completed
Warning Messages:
<Date and Time> WRN001:A2C3SID12
- PFA Error detected
Critical Messages:
<Date and Time> CRT001:A3C2SID04
- dead drive detected
<Date and Time> CRT002:A1C-SID
- not responding to commands
Please see the LEGAL - Trademark notice.
Feel free - send a for any BUG on this page found - Thank you.