Removing (NetBAY3) Cage Nuts


Removing (NetBAY3) Cage Nuts

Device installation might require the removal or moving of the rear-pane cage nuts. If you need to move the cage nuts, follow this procedure to move them and then go to (below) 'Installing Cage Nuts'. to install them in the correct position.

  1.  Hold the cage nut in place and compress the  cage-nut clip with a flat screwdriver blade.
     
  2.  With the cage nut-clip compressed, push the cage  nut-clip out of the square hole.
  3.  Release the screwdriver pressure on the clip. The  cage nut is now loose and can be removed from the  square hole.


Installing Cage Nuts: The nuts go toward the inside of the NetBAY3. Make sure you install all the cage nuts at the same level on the mounting rails.

  1.  Hook one side of the cage-nut clip into the  rack-mounting-rail square hole.
  2.  Hold the cage nut in place and compress the  cage-nut clip with a flat screwdriver blade.
  3.  With the cage-nut clip compressed, push the cage-nut  clip into the square hole.
  4.  Release the screwdriver pressure on the clip. The  cage nut is now locked in the square hole.

Back to  Jump to TOP-of-PAGE

Please see the LEGAL  -  Trademark notice.
Feel free - send a Email-NOTE  for any BUG on this page found - Thank you.