Installing Devices in the NetBAY3

Installing Devices in the NetBAY3

This appendix contains information about installing devices in the NetBAY3.

Note: The illustrations in this appendix do not show the server on top of the NetBAY3, however, you do not need to remove the NetBAY3 to install devices.

General Considerations: You can install three types of devices in the NetBAY3:

•  Devices, such as the IBM EXP10, that sit on side rails
•  Cantilevered devices, such as a power distribution  unit (PDU), that are screwed to the front or rear of the  NetBAY3
•  Devices that sit on the NetBAY3 base plate

1.  To allow the NetBAY3 front bezel to close,  devices with handles must not protrude out more  than 56 cm (2.2 in.). The following illustration of  the front bezel top-view cross section shows the  clearances.
2.  All device cables must exit from the rear of the  NetBAY3.

Please see the LEGAL  -  Trademark notice.
Feel free - send a   for any BUG on this page found - Thank you.