Hot-Swap Power Supply Installation
Hot-Swap Power Supply Installation
The server comes with one power supply. You can add a
second power supply to provide redundant power. After
you install a power supply, check the power-supply status
indicators to verify that the power supply is operating
properly. See 'Power Supplies' for details.
Never remove the cover on a power supply or any
part (power backplane and AC box) that has the
following label attached.
Hazardous voltage, current, and energy levels are
present inside the power supplies, power backplane,
and AC box. There are no serviceable parts inside the
power supplies, power backplane, or AC box.
Refer to the following illustration while performing the steps
in this procedure.
Note:
You do not need to turn off the power to the server to
install hot-swap power supplies.
To add a power supply:
Never remove the cover on a power supply or any
part (power backplane and AC box) that has the
following label attached.
Hazardous voltage, current, and energy levels are
present inside the power supplies, power backplane,
and AC box. There are no serviceable parts inside the
power supplies, power backplane, or AC box.
Note:
It is not necessary to turn the Power switch on the
power supply off when you are installing a power
supply.
- Remove the filler panel -3-:
- Remove the four screws -2- from the filler panel.
- Remove the filler panel -3- from the
power-supply bay and save it and the four
screws you removed for future use.
Note:
During normal operation, each power-supply
bay should have either a power supply or
filler panel installed for proper cooling.
- Place the handle -5- on the power supply in the open
position, and slide the power supply into the chassis.
- Gently close the handle -5- on the power supply to
seat the power supply in the bay.
- Plug the power cord for the added power supply into
power cord connector -1-.
When the power-cord strain-relief bracket option
is installed on the power cord, the server must be
plugged to a power source that is easily
accessible.
- Install a power-cord strain-relief bracket -10-, if
desired.
- Plug the power cord into a properly grounded
electrical outlet.
- Make sure the Power switch -6- on the power supply
is in the On position.
- Verify that the DC Power light -8- and AC Power light
-7- on the power supply are lit, indicating that the
power supply is operating correctly.
Back to
Please see the LEGAL - Trademark notice.
Feel free - send a for any BUG on this page found - Thank you.