Installing the Trim Bezels and Server Door


Installing the Trim Bezels and Server Door

Refer to the following illustration while you perform the steps in this procedure.

 

To install the media-bay trim bezel:
  1.  Insert the two tabs on the top of the media-bay trim  bezel -3- in the matching holes on the server  chassis.
  2.  Push the bottom of the bezel toward the server until  the two tabs at the bottom of the bezel snap into  place.


To install the NetBAY3 bezel:

  1.  Hook the tabs on the left side of the NetBAY3 bezel  -2- around the posts on the NetBAY3.
  2.  Gently push the right side of the bezel toward the  server until the bezel snaps into place.
  3.  Lock the NetBAY3 bezel.


To install the server front door:

  1.  Align the pins on the server door -1- with the hinges  on the server and slide the door down.
  2.  Close and lock the door.

Back to  Jump to TOP-of-PAGE

Please see the LEGAL  -  Trademark notice.
Feel free - send a Email-NOTE  for any BUG on this page found - Thank you.