ServeRAID Controller Administration
This section provides instructions for copying the drive configuration to the ServeRAID controller, copying the
ServeRAID controller configuration to the drives, initializing the ServeRAID controller configuration, and scanning for
new drives.
Copying the Drive Configuration to the ServeRAID Controller:
You can copy the configuration information stored on the hard disk drives to thr ServeRAID controller.
This procedure is useful when you install drives from other systems.
During the copy procedure, the ServeRAID controller automatically performs any necessary rearrangement
of the configuration, then, the controller writes the new configuration information back to the reserved
area on the configured hard disk drives.
To copy the drive configuration information to the ServeRAID controller:
Copying the ServeRAID Controller Configuration to the Drives
You can copy the configuration information stored in the ServeRAID controller to all configured hard disk drives.
To copy the ServeRAID controller configuration information to the drives:
You can copy the configuration information stored on the hard disk drives to the ServeRAID controller.
This procedure is useful when you install drives from other systems.
You can copy the configuration information stored in the ServeRAID controller to all configured hard disk drives.
Please see the LEGAL - Trademark notice.
Feel free - send a for any BUG on this page found - Thank you.