Removing the Server from a Rack (Netfinity 7000 - 8651)
Removing the Server from a Rack
Four people are required to move or lift the server.
To remove the server from a rack:
- If you have a modem or fax machine attached to the
server, disconnect the telephone line from the
electrical outlet and the server.
NOTE: If you are in the United Kingdom, you must
perform this step before disconnecting the power cord.
- Disconnect all cables and power cords from the rear of the server.
- Disconnect all power cords from the rack.
- Remove the screws from the bezel brackets on each
side of the front bezel. Set them aside for later use.
- Slide the server about halfway out of the rack.
- Loosen the captive screws that secure the cable-management arm.
- Fully extend the slide-bracket assemblies until they lock.
- Remove the screws that attach the server to each slide-bracket assembly.
- Remove the side access doors from the server by loosening the captive screws.
- Using the four handles on the side of the server, lift
the server from the slide bracket assemblies and
place the server on a flat, nonconductive surface.
- Install the side access doors on the server.
For proper cooling and airflow, replace the side
access doors before powering on the server.
Operating the server with the side access doors
removed might damage server components.
Back to
Please see the LEGAL - Trademark notice.
Feel free - send a for any BUG on this page found - Thank you.